top of page
THE BLACKWING SPORT
EBW-140

This is the little brother of our great Blackwing, this version is smaller, more agile and faster than the original one therefore it is more adequate if you are planning to make an aggressive flight. In case you wanna fly FPV the model has been designed to work with the camera Eachine TX02 or similar that can be directly powered by the receiver, there is no need of installing a flight controller or VTX allowing you to save weight, money and assembly time.

Includes:
-STL files

-G-codes for PLA and LW-PLA

€17

Features:

-FPV camera ready
-Wire skids for landing in asphalt

-Launch handle

Blackwing brothers
Blackwing
Blackwing
3D printed flying wing

SPECIFICATIONS

                                  LW-PLA    PLA
STRUCTURE WEIGHT       250g     450g

TAKE OFF WEIGHT          480g      700g
STALL SPEED                 24km/h  30km/h
WING LOADING             25g/dm² 37g/dm² 

WING SPAN               1400mm (55")

WING SURFACE          19dm2

WING ASPECT RATIO   9

ARRANGEMENT DRAWING AND PRINTING PARAMETERS​

Printing_parameters_.jpg

ALTHOUGH THE ASSEMBLY VIDEO BELONGS TO ANOTHER MODEL THE CONCEPT OF THE ASSEMBLY PROCESS IS THE SAME

SHOPPING LIST

ALL THE COMPONENTS THAT YOU HAVE TO BUY TO FLY THE AIRPLANE

3D PRINTER

MIN PRINTING VOLUME - 180x180X195 (X,Y,Z)
NOZZLE DIAMETER - 0,4 mm

​

Recommended

FILAMENT
QUANTITY - 250r (LW-PLA) or 450g (PLA or PETG)

Recommended

colorfabb.JPG

ECLIPSON STANDARD POWER PACK

SERVOS NEEDED - x2

​

Recommended

Captura.PNG

BATTERY

VOLTAGE - 11,1V (3S)

CAPACITY - 1000 mAh to 1500 mAh

DISCHARGE - >20C 

​

Recommended

BAT2

​

bat.jpg

RADIO CONTROL SYSTEM

MIN CHANNELS - 3CH

​

Recommended

Captura.JPG

FPV SYSTEM

​

Recommended

TX02.JPG

OTHER PARTS

-PUSH RODS - D1,2mm (min length 50mm)  2units
-BOLT - M3X15mm (with nuts and washers)  4units
-SCREW - M2X8mm (aprox)  30units
-VELCRO
-CARBON FIBER TUBE - D6x4mm (length 300mm) 1units

(Not necessary for PLA version)
-CARBON FIBER TUBE - D4x3mm (length 500mm) 2units
(Not necessary for PLA version)

-GLUE - cyanoacrylate + accelerator
-PUSH RODS CONNECTORS  2units
-WIRE - 0,5 mm
-SERVO LEAD EXTENSION
 (min 400mm) 2 units
-TAPE


Recommended

leads.JPG
Eclipson 3d printed aircraft
bottom of page